Factory Hand Sealer – YC450HR

YC450HR – Factory Hand Sealer

A sealer like this is intended for sealing plastic bags, in a production environment. It contains a power transformer which is capable of the repetitive demands of this type of usage. If required, this sealer can be fitted with an element 5mm wide (which we believe is unnecessary for sealing plastic). Its element is covered with a heat-resistant fabric which is coated with non-stick PTFE – from which soft plastic can be wiped easily.
If you wish to make bags from a roll of tubing, one of our sealers which have sharp cutting blades would be better. To use this sealer to make bags from tubing, use scissors, or use a box-cutter knife and a plank, to cut from the tubing.
There are other models of sealer, similar to this one, but intended for centre-folded film. To use this sealer to make bags from a roll of centre-folded plastic, we can fit for you additional insulation, and a round element (small additional cost). This will make it easy to melt through the centre-folded plastic, forming an open bag (not good with tubing, because this would form a closed bag).
An impulse-type sealer like this one – consumes power when sealing – very little power at all when merely switched on. This makes it suitable for intermittent use. There is no need to batch the sealing work or wait minutes for warm-up or cool-down before or after making seals.
On impulse sealers, the elements and insulating sheets (Teflon) are consumable. Order a spares pack with the sealer.

Voltage: 220
Number of Phases: 1
Frequency (Hertz): 50
Power Draw (Watts): 600
Seal Length (mm): 440
Seal Width (mm): 2,3
Seal Thickness (PE) (microns): 250
Seal Thickness (PP) (microns): 100
Net Mass (kg): 14,5
Packed Mass (kg): 15
Packed Length (cm): 72
Packed Width (cm): 45
Packed Height (cm): 23